Contents

Connection Status

You can check the connection status for registered projectors on the Epson Projector Connected Agent screen.

If the status indicates that a problem has occurred, see the following table for a solution.

Status

Problem and Solutions

Monitor Password Authentication Error

Enter the correct Monitor Password for the projector in the Epson Projector Connected Agent software.

Web Control Password Authentication Error

Enter the correct Web Control Password for the projector in the Epson Projector Connected Agent software.

ESC/VP.net Communication Error

  • Make sure that no devices other than the Epson projector are connected.

  • It might be a temporary error. Register the projector again.

  • Depending on your projector and the firmware version, you might need to set the Monitor Password and Web Control Password again. Set the password in the projector's menu, and then register the projector again.

TCP Connection Error

Make sure the IP address for the projector is set correctly.